Sunbeam Rapier Owners Club
Sunbeam Rapier Owners Club
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Technical
 Help!
 H120 clutch slave cylinder replacement

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File

   

T O P I C    R E V I E W
puffin Posted - 14 Oct 2021 : 13:10:55
Hi there,
Just moved house and can't find my workshop manual- Need to replace the clutch slave cylinder and wondered if there are any obvious snags- replacement sent by speedy spares is approx 3" overall in length with 2 horizontal screw fittings at rear, assume top for bleed nipple and bottom for pipe from master. All advice gratefully received!
David
1   L A T E S T    R E P L I E S    (Newest First)
IanEndurer Posted - 23 Oct 2021 : 14:03:36
Hi David,

Yes that's correct the bottom is to master and top is bleed nipple. Fairly straightforward to fit- remove rod from clutch arm(held on by split pin) then undo master feed then remove 2 fixing bolts- assembly is reversal of removing. Simply bleed system a d enjoy light clutch feel!
Good luck.
Ian.

Sunbeam Rapier Owners Club © 2009 Sunbeam Rapier Owners Club Go To Top Of Page
Snitz Forums 2000